User Tools

Site Tools


Sidebar

Translations of this page:



Kurts CNC Projects

en:ampel:controller

CNC warning light

Controller

I use an ESP8266 D1 Mini Board, but almost any other ESP8266 or ESP32 controller will work, you just have to change the GPIO numbers.

To control the on/off lines of the warning light I use the outputs D5, D6 and D7 (see firmware).

Connections:

ControllerLight
D5Yellow on/off
D6Green on/off
D7Red on/off
GNDblack cable (minus)
This website uses cookies. By using the website, you agree with storing cookies on your computer. Also you acknowledge that you have read and understand our Privacy Policy. If you do not agree leave the website.More information about cookies
en/ampel/controller.txt ยท Last modified: 2022/01/10 00:31 (external edit)